A.Too much refrigerant
B.Too little refrigerant
C.Refrigerant is ran out
D.Running is over
您可能感興趣的試卷
你可能感興趣的試題
A.increase
B.reduce
C.maintain constant
D.None of the above is true
Which of the following may cause that excessively warm water leaves the condenser in a refrigeration plant? （）
(1) too little cooling water
(2) too much cooling water
(3) too warm cooler water
A.（1）only
B.anyof（1），（2）and（3）
C.anyof（1）and（3）
D.anyof（1）and（2）
Which of the following may cause that the compressor cuts off on high pressure cutout in a refrigeration plant? （）
(1) faulty condensing
(2) too few refrigerant
(3) high discharge pressure
A.any of (1) and (3)
B.any of (1) and (2)
C.any of (2) and (3)
D.any of (1), (2) and (3)
A.cutout
B.controller switch
C.pressure controller
D.cutout switch
A.evaporator
B.compressor
C.condenser
D.none of the above
最新試題
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
A grease gun is generally used to lubricate a （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
A salinity indicator is used to determine the （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
Thermostatic expansion valves can be adjusted for （）.
The general purpose of a heat exchanger is to （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.