A.closely observe the pump discharge temperature
B.close off the discharge valve, and watch for a rise in pressure
C.momentarily close off the suction valve, and watch for a rise in pressure
D.use a clamp on ammeter and compare the readings to past records
您可能感興趣的試卷
你可能感興趣的試題
A.removing all but the frictional load during starting
B.relieving intercoolers of high temperature buildups
C.providing high starting torque in the drive motor
D.seating valve plates during compressor shutdown
A.loose expansion valve control bulb
B.low differential setting on the H-Pcutout
C.blown fuse in the motor circuit
D.faulty suction pressure regulator
A.prevent an internal explosion in the pump when it is overheated
B.enable a visual inspection of the pump while it is running
C.insure a proper alignment of the pump coupling to the driver
D.accommodate for friction between the impeller and the easing
A.explosive range
B.flash point
C.ignition temperature
D.combustion temperature
A.the pressure regulating valve is not closing
B.an excessive lack of refrigerant in the system
C.badly leaking discharge valves
D.worn piston rings
最新試題
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
A grease gun is generally used to lubricate a （）.
The general purpose of a heat exchanger is to （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
Which of the following statements is correct concerning heat transfer?（）
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.