A.air bubbles in the sight glass
B.any leaks in the system
C.over-travel in the rudder angle indicator
D.lost motion in the rams
您可能感興趣的試卷
你可能感興趣的試題
A.The pump delivers full capacity when started, but gradually slackens off toan abnormally low flow
B.The pump packing gland overheats after short operating periods
C.The motor over-current protective device continually shuts the pump down
D.Pounding noises can be heard at the pump suction chest
A.diameter of the discharge piping, with all other factors remaining the same
B.diameter of the suction piping, with all other factors remaining the same
C.width of the impeller only
D.diameter of the impeller
A.run continuously
B.not start
C.have high discharge pressure
D.short cycle on the high pressure switch
A.Electrical energy
B.Thermal energy
C.Potential energy
D.Kinetic energy
A.sliding block
B.pintle
C.reaction ring
D.tilting box or swash plate
最新試題
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.