A.dead band action
B.neutral zone action
C.range
D.on-off action
您可能感興趣的試卷
你可能感興趣的試題
A.cavitation
B.electrolysis
C.abrasion
D.corrosion
A.the relief valve should open before the high pressure cutout
B.the relief valve should open and allow the excess refrigerant to flow to the receiver
C.the high pressure cutout switch should operate before the relief valve opens
D.you should close in on the suction valve
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.restriction in refrigerant piping
B.air and non-condensable gases in the condenser
C.water in the refrigerant
D.flooding back of liquid refrigerant from the evaporator
A.A shortage of liquid refrigerant
B.Excessive frost on the evaporator
C.Excessive condenser cooling water
D.Insufficient condenser cooling water flow
最新試題
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
A salinity indicator is used to determine the （）.
One cause of high head pressure occurring in a refrigeration system can be （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.