A.signaling that all personnel are clear before lifting or lowering material
B.Examining material for sharp edges or protruding points before handling
C.Closing, tagging, or securing valves that permit entrance of steam, water, or air into a fitting or other equipment
D.Throwing materials from high places to the deck
您可能感興趣的試卷
你可能感興趣的試題
A.The expansion tank should be topped off
B.The thermostatic water regulating valves should be manually opened
C.The fuel filters should be changed
D.The engine should be turned over slowly with the indicator cocks open
A.Full Ahead
B.Half Ahead
C.Full Astern
D.Half Astern
A.overheating of the lube oil
B.over-speeding of the motor
C.wear on the braking system
D.damage to the teeth
A.Send the wiper into the well with only a scoop and pail
B.Remove the bilge manifold valve and attempt to back flush the line
C.Simultaneously operate all available bilge pumps
D.It is only necessary to transfer half the contents of a drum of degreaser into the bilge well
A.Send the wiper into the well with only a scoop and pail
B.Remove the bilge manifold valve and attempt to back flush the line
C.Simultaneously operate all available bilge pumps
D.It is only necessary to transfer half the contents of a drum of degreaser into the bilge well
最新試題
If separating effect is not good, which measure should be taken ()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
The ISPS Code consists of a mandatory section-Part A, which shows()
To proceed to the assistance of a ship in distress is()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Which of the following items don’t belong to dock repair works?()
Under MARPOL Code the ship to which it applies has to carry ()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()