A.centrifugal force rotates the ball-head
B.flyweight centrifugal force is balanced by spring force
C.flyweight centrifugal force is balanced by hydraulic pressure
D.speeder spring alone actuates the fuel control rod
您可能感興趣的試卷
你可能感興趣的試題
A.too light of a load
B.injection timing is too early
C.overloading of the engine
D.too low of a compression ratio
A.caused by retarded injection timing
B.caused by a mechanical defect in one cylinder
C.caused by high fuel injection pressures
D.normal for these conditions
A.an air bound fuel system
B.damage to cylinder heads and pistons
C.excessive fuel injection
D.excessive air valve lift
A.excessive fuel oil temperature
B.long periods of engine overload
C.metallic contact between nozzles and cylinder heads
D.hard carbon deposit and varnish on the nozzles
A.opposed to the crankshaft rocking couple
B.resonant with the crankshaft natural frequency
C.critical fore and aft crankshaft vibrations
D.horizontal whipping motions of the crankshaft
最新試題
Under MARPOL Code the ship to which it applies has to carry （）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The condensers located in various stages of a flash evaporator are cooled by（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If separating effect is not good, which measure should be taken （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
Diesel engine air start system check valves are opened by （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）