A.obtain injection lag
B.help mix fuel and air
C.increase combustion pressure
D.utilize higher injection pressures
您可能感興趣的試卷
你可能感興趣的試題
A.thermal efficiency
B.mechanical efficiency
C.brake thermal efficiency
D.volumetric efficiency
A.wide compression rings are used
B.oil rings are located above the piston
C.chromium plating is used on all piston rings
D.oil rings are located near the bottom of the piston skirt
A.runs out of fuel
B.has low lubricating oil pressure
C.exceeds a set maximum speed
D.has high cooling water temperature
A.prevent any lubricant from reaching
B.prevent excessive lubrication from reaching the combustion space
C.Provide metal-to-metal contact to seal the cylinder against blow-by
D.assure a positive means of scraping carbon accumulation from the cylinder
A.Dull black appearance
B.Bright appearance
C.Thin layer of lacquer
D.Thick oily film
最新試題
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The ISPS Code consists of a mandatory section-Part A, which shows（）
Using a file without a handle may result in （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）