單項選擇題

Refer to the exhibit. What can be determined about the router from the console output?（）

A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is the most efficient summarization that R1 can use to advertise its networks to R2（）。

A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24

2.多項選擇題Which two statements describe the Cisco implementation of VLANs? （）

A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.

3.單項選擇題

The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do（）。

A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router

4.多項選擇題What are three characteristics of the OSPF routing protocol? （）

A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.

5.單項選擇題A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782.The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?（）

A.Router R2 will not form a neighbor relationship with R1.
B.Router R2 will obtain a full routing table, including a default route, from R1.
C.R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D.R2 will not have a route for the directly connected serial network, but all other directly connected