A.SW1#show swithport port-security interface FastEthernet 0/12
B.SW1# show swithport port-secure interface FastEthernet 0/12
C.SW1# show port-secure interface FastEthernet 0/12
D.SW1#show running-config
E.SW1#show port-security interface FastEthernet 0/12
您可能感興趣的試卷
你可能感興趣的試題
A.最低端口MAC地址
B.端口的優先級號和MAC地址
C.VTP修訂號
D.最高的端口優先級數量
E.路徑開銷(cost)
A.RSTP鏈路故障后顯著減少拓撲聚合時間
B.RSTP通過增加備用和備份角色的消費STP端口角色
C.RSTP端口atates被阻塞,丟棄,learing,或轉發
D.RSTP還使用STP proprsal-協議序列
E.RSTP使用相同的定時器baseed過程STP上點至點鏈接
F.在點到點鏈路提供比STP更快的傳輸和轉發
A.VTP
B.802.1Q
C.RSTP
D.STP
Refer to the exhibit.A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements?()
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
最新試題
請參見圖示。下列哪組設備僅包含中間設備?()
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()
以下哪兩種介質可提供高達1Gb/s 的帶寬?()
下列哪些是私有IP 地址的地址范圍?()
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()