Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2.What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails，without using any type of EtherChannel link-bundling？（）
A. Increase the root bridge priority （increasing the numerical priority number） for VLAN 2 on Catalyst D so that port D2 becomes the root port on Catalyst D for VLAN 2.
B. Decrease the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
C. Decrease the path cost on R2 on Catalyst R for VLAN 2 so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
D. Increase the root bridge priority （decreasing the numerical priority number） for VLAN 2 on Catalyst R so that R2 becomes the root port on Catalyst D for VLAN 2.
您可能感興趣的試卷
你可能感興趣的試題
A.Loop guard only operates on interfaces that are considered point-to-point by the spanning tree.
B.Loop guard only operates on root ports.
C.Loop guard only operates on designated ports.
D.Loop guard only operates on edge ports.
A.It may allocate IP addresses from an unknown subnet to the users.
B.All multicast traffic can be sniffed by using the DHCP multicast capabilities.
C.The CPU utilization of the first hop router can be overloaded by exploiting DHCP relay open ports.
D.A potential man-in-the-middle attack can be used against the clients.
A. 1） lowest root bridge id，2）lowest sender bridge id，3）lowest port id，4）lowest root path cost
B. 1） lowest root path cost，2）lowest root bridge id，3）lowest sender bridge id，4）lowest sender port id
C. 1） lowest root bridge id，2）lowest sender bridge id，3）lowest root path cost 4）owest sender port id
D. 1） lowest root bridge id，2）lowest root path cost，3）lowest sender bridge id，4）lowest sender port id
A. VTP updates are ignored and forwarded out all ports.
B. VTP updates are ignored and forwarded out trunks only.
C. VTP updates are made to the VLAN database and are forwarded out trunks only.
D. VTP updates are ignored and are not forwarded.
A.Increase the shaping rate for the priority queue.
B.Remove the policer applied on the priority queue.
C.Remove the shaper applied on the priority queue.
D.Increase the policing rate for the priority queue.
最新試題
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Which of these statements about penultimate hop popping are true？（）
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which two statements about SA caching are true？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）