Refer to the exhibit. Routers A and B are directly connected. Given the configuration， how many EIGRP routes will router B see in its routing table？（）
A. 0
B. 1
C. 2
D. 3
E. 4
您可能感興趣的試卷
你可能感興趣的試題
A. LSA 1
B. LSA 3
C. LSA 4
D. LSA 5
E. LSA 7
A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas （external route）.
A.00000
B.12345
C.23456
D.65000
E.99999
A. The Layer 2 multicast address of the destination node
B. The solicited node multicast address of the destination node
C. The Layer 2 address of the destination node based on the destination IPv6 address
D. The IPv6 address of the destination node based on the destination Layer 2 address
A.6to4
B.6over4
C.ISATAP
D.GRE
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which multicast address is reserved for cisco-rp-discovery？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
Which two EIGRP options will limit a query domain？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）