單項選擇題Which mechanism does OSPFv3 use when the router LSA is too big to be sent out?()

A.It relies on IPv6 to do the fragmenting.
B.It splits the LS Update packet into smaller packets.
C.It splits the LSA into smaller router LSA packets.
D.It produces an error.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. Routers A and B are directly connected and running OSPF, but they are unable to form a neighbor relationship. What is the most likely cause?()

A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.

2.單項選擇題

Refer to the exhibit. Routers A and B are directly connected and running EIGRP, but they are unable to form a neighbor relationship. What is the most likely cause? ()

A. The network statements are misconfigured.
B. The IP address statements are misconfigured.
C. The autonomous system is misconfigured.
D. There is a physical issue with the cable.

4.單項選擇題Which OSPF LSA type does an ASBR use to originate a default route into an area? ()

A. LSA 1
B. LSA 3
C. LSA 4
D. LSA 5
E. LSA 7

5.單項選擇題Which one of these statements is true of OSPF type 5 LSAs? ()

A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas (external route).

最新試題

You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked?()

題型:單項選擇題

Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()

題型:單項選擇題

In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group?()

題型:單項選擇題

Which multicast address is reserved for cisco-rp-discovery?()

題型:單項選擇題

An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()

題型:單項選擇題

On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()

題型:單項選擇題

In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()

題型:多項選擇題

Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()

題型:單項選擇題

In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()

題型:單項選擇題

How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU?()

題型:單項選擇題