A. atm-dxi
B. frame-relay
C. hdlc
D. lapb
E. ppp
您可能感興趣的試卷
你可能感興趣的試題
A. show protocols
B. show process
C. show system
D. show version
A. debug icmp
B. debug ip icmp
C. debug tcp
D. debug packet
A. show ip route
B. show route
C. traceroute
D. trace ip route
A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
A. ip route 172.16.1.0 255.255.255.0 0.0.0.0
B. ip route 172.16.1.0 255.255.255.0 172.16.2.1
C. ip route 0.0.0.0 255.255.255.0 172.16.2.1
D. ip route 0.0.0.0 0.0.0.0 172.16.2.1
最新試題
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
On which options are standard access list based?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
Which IPsec security protocol should be used when confidentiality is required?()
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()