A. LAN
B. routing
C. WAN
D. network
您可能感興趣的試卷
你可能感興趣的試題
A. presentation
B. session
C. transport
D. network
E. physical
A. transport
B. network
C. presentation
D. session
E. application
A. minimum cell rate (MCR)
B. quality of service (QoS)
C. modulation
D. packet switching exchange (PSE)
E. reliable transport protocol (RTP)
A. bandwidth
B. delay
C. load
D. reliability
A. atm-dxi
B. frame-relay
C. hdlc
D. lapb
E. ppp
最新試題
Which statement describes the rule of split horizon?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
Which pairing reflects a correct protocol-and-metric relationship?()
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
What is the default administrative distance of OSPF?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()