單項選擇題In which integration method is an IPV6 packet encapsulated within an IPV4 protocol?()

A. proxy.
B. dual-stack
C. tunneling
D. dot1q


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題The enable secret command is used to secure access to which CLI mode?()

A. user EXEC mode
B. global configuration mode
C. privileged EXEC mode
D. auxiliary setup mode

2.單項選擇題Which statement about vlan operation on cisco catalyst switches is true?()

 A. when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B. unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C. ports between switches should be configured in access mode so that vlans can span across the ports
D. broadcast and multicast frames are retransmitted to ports that are configured on different vlan.

3.單項選擇題A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()

A. an OSPF update for network 192.168.0.0/16
B. a static router to network 192.168.10.0/24
C. a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
D. a RIP update for network 192.168.10.0/24
E. a directly connected interface with an address of 192.168.10.254/24
F. a default route with a next hop address of 192.168.10.1

5.單項選擇題Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network addres?()

A. 172.16.16.0
B. 172.16.24.0
C. 172.16.0.0
D. 172.16.28.0

最新試題

What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()

題型:單項選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:單項選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:單項選擇題

Which statement is true, as relates to classful or classless routing?()

題型:單項選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:單項選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題