A.Reload the active VLAN configuration
B.Clear the affected port and bring it up again
C.Explicitly set the trunk for the VLAN to be on
D.Remove all the VLANs set
您可能感興趣的試卷
你可能感興趣的試題
A.The link is using IEEE 802.1Q protocol
B.The link is using IEEE 802.1E protocol
C.Spanning tree is disabled
D.Not enough information to determine
E.The native VLAN information is identical at each end of the link
F.The native VLAN information is different at each end of the link
A.IEEE 802.1Q
B.IEEE 802.10
C.Misconfigured NIC
D.User configuration
E.All of the above
A.SW13 has a higher VTP configuration revision than the current VTP revision
B.SW13 is configured as a VTP server with a different domain name
C.SW13 is configured as a VTP server with the domain name R1
D.SW13 has a lower VTP configuration revision than the current VTP revision
E.SW13 is not configured to participate in VTP
F.SW13 is configured with only VLAN1
On the basis of the following exhibit， can you tell me why VLAN updates from switch CK-P2S1 arenot applied to switch CK-P1S1？（）
A.The MD5 digests do not match
B.Switch CK-P1S1 is in transparent mode
C.The passwords do not match
D.The VTP domains are different
A.In a 6to4 tunnel， the first two bytes of the IPv6 address will be 0x2002 and the next four byteswill be the hexadecimal equivalent of the IPv4 address
B.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the2002：1315：4463：1：：/64 IPv6 address
C.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/48IPv6 address
D.In a 6to4 tunnel， the first two bytes of the IPv6 address will be locally derived and the next twobytes will be the hexadecimal equivalent of the IPv4 address
E.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/16IPv6 address
最新試題
Drag and drop each management protocol on the above to the correct category on the below.
Which three statements accurately describe IOS Firewall configurations？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Which statement correctly describes IPsec VPN backup technology？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
cisco ios command to interface dialer 0
Match the xDSL type on the above to the most appropriate implementation on the below.
Drag the DSL local loop topic on the left to the correct descriptions on the right.