A.NAT mapping
B.NAT overloading
C.NAT caching
D.Static NAT
E.Dynamic NAT
F.Overlapping NAT
您可能感興趣的試卷
你可能感興趣的試題
A.The network is load balancing among different members of the VRRP group
B.The default hello timers are 1 second
C.The interface IP address is being used as the virtual IP address
D.There are several routers in the group simultaneously forwarding traffic for the group
E.It is a Cisco Proprietary protocol
F.The default hello timers are 3 seconds
A.A routed port does not run STP or DTP
B.A routed port is considered to be in a down state if it is not operational at both Layer 1 andLayer 2
C.An SVI is considered to be in a down state if it is not operational at both Layer 1 and Layer 2
D.An SVI is considered to be in a down state only when none of the ports in the correspondingVLAN are active
E.An SVI port does not run 5TP or DTP
F.To create a trunk， an SVI can be logically divided into subinterfaces
A.The interface you configured for AutoQoS is set to half-duplex
B.AutoQoS was configured on only one end of the link
C.The interface you configured for AutoQoS has no IP address
D.The interface’s bandwidth is not correctly configured
E.CEF is not enabled on the interface
F.You enabled AutoQoS on the interface but forgot to enable globally first
A.Spanning Tree Protocol
B.Cabling
C.Frame forwarding
D.Packet forwarding
E.EtherChannel
F.Routing protocols
A.Building schematic
B.IGP community elements
C.Listing of interconnections
D.Physical topology diagram
E.Logical topology diagram
F.Inventory of network equipment
最新試題
Drag and drop each management protocol on the above to the correct category on the below.
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
cisco ios command to interface dialer 0
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）