單項選擇題

You are configuring a Cisco multilayer switch for the Company network.
Which command would you use to configure a port to act as a routed interface？（）

A. ip routing
B. switchport mode trunk
C. no switchport
D. switchport trunk native vlan 1
E. None of the other alternatives apply

你可能感興趣的試題

多項選擇題

Which of the following could be used to provide a Layer 3 data path between separate VLANs？（）

A. VLAN trunking
B. An external router
C. An internal route processor
D. VLAN capable bridge
E. EtherChannel

多項選擇題

Inter-VLAN routing has been implemented in the Company network. In VLAN routing，
what are some of the disadvantages of designing a router-on-stick configuration？（）

A. InterVLAN routing cannot be filtered by the router.
B. The router becomes a single point of failure for the network.
C. Routers will not route STP BPDUs.
D. There is a possibility of inadequate bandwidth for each VLAN.
E. Additional overhead on the router can occur.
F. NetFlow Switching is required for InterVLAN accounting.

You are configuring a Cisco multilayer switch for the Company network. Which command would you use to configure a port to act as a routed interface？（）

你可能感興趣的試題

Which of the following could be used to provide a Layer 3 data path between separate VLANs？（）

Inter-VLAN routing has been implemented in the Company network. In VLAN routing， what are some of the disadvantages of designing a router-on-stick configuration？ （）

You are configuring a Cisco multilayer switch for the Company network.
Which command would you use to configure a port to act as a routed interface？（）

Which of the following could be used to provide a Layer 3 data path between separate VLANs？（）

Inter-VLAN routing has been implemented in the Company network. In VLAN routing，
what are some of the disadvantages of designing a router-on-stick configuration？（）