Which three statements are true about implementing wireless LANs in the Company network using Cisco devices？（）
A. Antenna power is a relative value reference to dBi.
B. LWAPP allows encrypted communications between lightweight access points and WLAN controllers.
C. Characteristics of antennas are directionality， gain， and polarization.
D. Power over Ethernet （PoE） is only available when a WLAN controller is integrated into the network.
E. The WLAN solution Engine （WLSE） is used to control lightweight access points.
F. One of the advantages of the lightweight WLAN solution is that the devices act indepently.
您可能感興趣的試卷
你可能感興趣的試題
Under which three conditions does a client initiate roaming between wireless cells in the Company WLAN？ （）
A. The access point has broadcast too many SSIDs.
B. The wireless client has missed too many beacons from the access point.
C. The maximum data retry count， initiated by the wireless client， is exceeded.
D. The wireless client has reduced the data rate.
E. The access point has requested client reauthentication.
F. The wireless client has missed too many IAPP （Inter Access Point Protocol） updates.
Refer to the exhibit. The wireless user is moving from right to left towards AP2.
What are three reasons that the wireless client would initiate roaming？（）
A. The minimum data retry count from AP1 is exceeded.
B. The maximum data retry count from AP1 is exceeded.
C. The client has missed too many beacons from AP1.
D. The client data rate from AP1 has been reduced.
E. The client has received too many beacons from AP2.
F. The client data rate from AP2 has been increased.
Refer to the exhibit.
Which protocol establishes an optimal path to the root in a wireless mesh network？ （）
A. Adaptive Wireless Path （AWP）
B. WLAN Quality of Service （WQoS）
C. Lightweight Access Point Protocol （LWAPP）
D. 802.1Q WLAN trunking protocol
E. Layer 2 Roaming （IAPP）
Refer to the exhibit.
Which statement is true about the repeater access point that is deployed in this wireless network？（）
A. The repeater access point should use a different SSID than the SSID configured on the parent access point.
B. The repeater access point reduces the throughput in half because it receives and then retransmits each packet on the same channel.
C. The repeater access point requires a 10 percent channel overlap with channel of the root access point.
D. The repeater access point should use a different WEP encryption method than the WEP encryption that is enabled on the parent access point.
In the Company wireless LAN，
what is the function of the Service Set Identifier （SSID）？（）
A. The SSID must match on both the Company client and the Company access point and provides MAC Address Authentication to authenticate the client to the access point.
B. The SSID should be configured on the Company client site only and provides data-privacy functions and authentication to the access point.
C. The SSID must match on both the Company client and the Company access point and provides encryption keys for authentication to the access point.
D. The SSID must match on both the Company client and the Company access point. The SSID is advertised in plain-text in the access point beacon messages.
E. None of the other alternatives apply
最新試題
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）
Which statement is correct about RSTP port roles？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
Which three statements about STP timers are true？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Which two statements are true about BPDU port-guard and BPDU filtering？（）
Which two statements are true when the extended system ID feature is enabled？ （）
What two things will occur when an edge port receives a BPDU？（）