A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
您可能感興趣的試卷
你可能感興趣的試題
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
During voice implementation，
which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication？（）
A.allowed codecs
B.native VLAN
C.auxiliary VLAN
D.Cisco Unified Communications Manager IP address
E.RSTP
A network is deployed using best practices of the enterprise campus network model， including users with desktop computers connected via IP phones. Given that all components are QoS-capable，
where are the two optimal locations for trust boundaries to be configured by the network administrator？（）
A.host
B.IP phone
C.access layer switch
D.distribution layer switch
E.core layer switch
Wireless has been operating correctly in the campus infrastructure. After the wireless controllers are upgraded from LWAPP to CAPWAP， access points no longer boot and operate normally.
What is the most likely issue causing this problem？（）
A.VLAN assignments
B.DHCP option 43
C.PoE
D.ACL
E.QoS
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly， however， wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following：
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem？（）
A.QoS trust should not be configured on a port attached to a standalone AP.
B.QoS trust for switchport mode access should be defined as "cos".
C.switchport mode should be defined as "trunk" with respective QoS.
D.switchport access vlan should be defined as "1".
最新試題
Which two statements about the various implementations of STP are true？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）
Which statement is correct about RSTP port roles？（）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）