If a metric is not specified for routes that are redistributed into OSPF, the defaul t metric that is assigned to the routes is 20, except for redistributed BGP routes.
What is the metric that is assigned to redistributed BGP routes?（）
A. 200
B. 0
C. 1
D. 10
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which interoperability technique implemented on the dual - stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the 2002::/16 prefix? （）
A. Dual Stack
B. NAT - PT
C. 6to4 tunnel
D. GRE tunnel
E. ISATAP tunnel
Refer to the exhibit. EIGRP has been configured on al l routers in the network. The command metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric is used in the path calculations. Which router will R1 select as the successor and feasible successor for Network A?（）
A. R 4 becomes the successor for Network A and will be placed in the routing table. R2 becomes the feasible successor for Network A
B. R4 becomes the successor for Network A and will be included in the routing table. No feasible successor will be selected a s the advertised distance from R2 is higher than the feasible distance
C. R2 becomes the successor and will be placed in the routing table. R4 becomes the feasible successor for Network A
D. R2 becomes the successor and will be placed in the routing t able. No feasible successor will be selected as the reported distance from R4 is lower than the feasible distance
A. 01 - 00 - 5e - 7f - 00 - 01
B. 01 - 01 - ef - ff - 00 - 01
C. 00 - 00 - 00 - 7f - 00 - 01
D. 10 - 00 - ef - ff - 00 - 01
Refer to the exhibit. Router RTA has been configured as a DHCP server. The two debug commands will generate output on RTA when Ho st A requests an IP address. Which set of DHCPD debug messages is in the correct sequence?（）
A.DHCPD: Sending DHCPOFFER to client DHCPD: DHCPDISCOVER received from client DHCPD: DHCPREQUEST received from client DHCPD: Sending DHCPACK to client
B.DH CPD: DHCPDISCOVER received from client DHCPD: DHCPREQUEST received from client DHCPD: Sending DHCPOFFER to client DHCPD: Sending DHCPACK to client
C.DHCPD: DHCPDISCOVER received from client DHCPD: Sending DHCPOFFER to client DHCPD: DHCPREQUEST received from client DHCPD: Sending DHCPACK to client
D.DHCPD: DHCPREQUEST received from client DHCPD: Sending DHCPOFFER to client DHCPD: DHCPDISCOVER received from client DHCPD: Sending DHCPACK to client
E.DHCPD: Sending DHCPACK to client DHCPD: DHCPD ISCOVER received from client DHCPD: Sending DHCPOFFER to client DHCPD: DHCPREQUEST received from client
F.DHCPD: DHCPDISCOVER received from client DHCPD: Sending DHCPACK to client DHCPD: Sending DHCPOFFER to client DHCPD: DHCPREQUEST received from client
A. Based on the default timers, OSPF d etects a failure faster than IS - IS does.
B. OSPF default timers permit more tuning than IS - IS does.
C. IS - IS is more efficient than OSPF in the use of CPU resources.
D. OSPF is more scalable than IS - IS because of its ability to identify normal, stub, an d NSSA areas.
E. IS - IS and OSPF are both Open Standard, link - state routing protocols which support VLSM.
最新試題
Which of the following answers lists a multicast IPv6 address?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1
The following output occurs on Router R1 , which runs both EIGRP for IPv6 and OSPFv3, with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25 command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following should be true of redistribution in this case?（）D 2000::/64 [90/1422516]via FE80::213:19FF:FE7B:5026, Serial0/0/1C 2000:0:0:1::/64 [0/0]via Serial0/0/1, directly connectedL 2000::1:213:19FF:FE7B:5004/128 [0/0]via Serial0/0/1, receive
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?（）
The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?（）
Which of the following features work the same in both RIP- 2 and RIPng?（）
Look at the following configuration below and select the statements that are true.（）RD2(config)#router ospf 100RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - meRD2(config -router)#!RD2(config - router) #ip access - list standard match - meRD2(config - std - nacl)# permit host 172.16.0.0
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, and into the core of an Enterprise network. The branch also allows local hosts to communicate directly with public sites in th e Internet over this same DSL connection.Which of the following answers defines how the branch NAT config avoids performing NAT for the Enterprise directed traffic but does perform NAT for the Internet - directed traffic?（）
Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（）interface f0/0ipv6 address 2345:0:0:8::1/64
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）