The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?（）
ip sla
1
icmp - echo 1.1.1.1 source -ip 2.2.2.2
ip sla schedule 1 start - time now life forever
A. The SLA operation will be configured but will not start until additional commands are used
B. The SLA operation is not comp letely configured so it will not collect any datA
C. The SLA operation is complete and working, collecting data into the RTTMON MIB
D. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration
您可能感興趣的試卷
你可能感興趣的試題
A. ICMP Echo
B. VoIP (RTP)
C. IPX
D. SNMP
The following output occurs on Router R2. Which of the following statements can be confirmed as true based on the output from R2?（）
R2# show ip policy
Interface Route map
Fa0/0 RM1
Fa0/1 RM2
S0/0/0 RM3
A. R2 will forward all packets that enter Fa0/0 per the PBR configuration.
B. R2 will use route map RM2 when determining how to forward packets that exit interface Fa0/1.
C. R2 will consider using PBR for all packets exiting S0/0 /0 per route map RM3.
D. R2 will consider using PBR for all packets entering S0/0/0 per route map RM3.
Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What will Router R1 do with the packets generated by host 172.16.3.3 because of the telnet,assuming the packets enter R1's F0/0 interface?（）
interface Fastethernet 0/0
ip address 172.16.1.1 255.255.255.0
ip policy route - map Q2
!
route - map Q2 permit
match ip address 101
set interface s0/0/1
!
access - list 101 permit tcp host 172.16.3.3 172.16.4.0 0.0.0.255
A. The packet will be forwarded out S0/0 /1, or not at all.
B. The packet will be forwarded out S0/0/1 if it is up.
C. The packet will be forwarded out S0/1/1 if it is up.
D. The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E. The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
A. Packets entering F0/0 will be compared based on the PBR route map.
B. Packets exiting F0/0 will be compared based on the PBR route map.
C. IOS ignores the PBR forwarding directions wh en the packet matches a route map deny clause.
D. IOS ignores the PBR forwarding directions when the packet matches a route map permit clause.
A. Kilobits/seconD
B. Tens of microseconds
C. Cost
D. Hop count
E. No unit is assigneD
最新試題
Which of the following answers lists either a protocol or function that can be used by a host to dynamically learn its own IPv6 address?（）
Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?（）ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
Router R1 lists the following output from a show command. Which of the following is true about R1?（）R1# show ip v6 interface f0/0FastEthernet0/0 is up, line protocol is upIPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456No Virtual link - local address(es):Global unicast address(es):2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI]Jo ined group address(es):FF02::1FF02::2FF02::1:FF:12:3456
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
An ISP has assigned prefix 3000:1234:5678::/48 to Company1. Which of the following terms would typically be used to describe this type of public IPv6 prefix?（）
Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（）interface f0/0ipv6 address 2345:0:0:8::1/64
Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1
Which of the following answers lists a multicast IPv6 address?（）