A. An information trap is sent to the SNMP server.
B. Informational and debug messages are logged to the syslog server.
C. All messages are sent to the logging host, where selections are made.
D. All messages from emergencies to informational are sent to the logging host.
您可能感興趣的試卷
你可能感興趣的試題
A. When a router receives a failure response, it stops querying authentication methods.
B. When a router receives an error response, it stops querying authentication methods.
C. If the router receives a failure response from an authentication method, it queries the next method.
D. The router does not differentiate between failure and error responses; the authentication process is always interrupted.
E. If it receives no response from the authentication method, a router will determine the error condition on its own; the router also has the option to proceed to the next method in a list if configured accordingly.
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. Single group HSRP is used to achieve more efficient link utilization.
E. The return traffic is influenced by HSRP load sharing configuration.
A. RIP does not support routing contexts
B. routing contexts are implemented in a single routing process
C. routing contexts are implemented using multiple routing processes
D. routing contexts are implemented as several instances of a single routing process
E. routing contexts are implemented as a single instance of several routing processes
A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces
A. to make CEF tables smaller
B. to enable label switching on the frame mode interface
C. to restrict MPLS availability to predefined time periods
D. to restrict label switching to a limited number of networks
E. to restrict end users from seeing the routers in the MPLS network
最新試題
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?（）
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
Refer to the exhibit. Which SSH sessions will the SSH server accept?（）
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）