A. On the CE router, PE neighbors must be configured in the VRF context on the CE router
B. On PE routers, the CE IBGP neighbors are configured in the global BGP configuration
C. On PE routers, the CE EBGP neighbors are configured in the VRF context
D. A separate BGP process must be used on the PE routers for CE routers so that they do not use the same BGP routing process as that used for the PE router's other provider neighbors
您可能感興趣的試卷
你可能感興趣的試題
A. EIGRP can be used only as the PE-CE routing protocol if the PE and CE routers are in the same AS
B. Other EIGRP AS routes are automatically advertised to the CE router and do not require a redistribution configuration command to be configured
C. Unlike other routing protocols that are used between PE and CE routers, EIGRP supports backdoor links
D. Configure of the VPN is only required on the PE router
The router SIS-R has been configured in a CIS network. As a network administrator, you were required to enable MPLS on that router.
Which of the following description is making sense on the basis of the output information?（）
A. CEF switching is only needed to forward labeled packets.
B. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.
C. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.
D. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
A. Cisco Proprietary payload compression
B. Predictor payload compression
C. RTP header compression
D. TCP header compression
A.Version 1
B.Version 5
C.Version 4
D.Version 3
A. By calculating the time offset from the GPS or atomic clock
B. By setting the router clock to the default value if the router can't connect to a time server
C. By setting all network devices to the correct time
D. By setting necessary time date in the timestamp information
最新試題
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
Which command displays only those entries in a BGP table with specific AS_PATH attributes?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
What is the purpose of using VPN hardware acceleration equipment?（）
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?（）
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
When a Cisco router is configured for SSH, it acts as an （）?