A customer has 2 E1s to add between far-end nodes in an SNCP ring.
What type of circuit should you recommend？ （）
A. LO-PATH circuits
B. HO-PATH circuits
C. 1：1 protection circuits
D. 1：N protection circuits
E. LO-TUNNEL tunnel circuits
您可能感興趣的試卷
你可能感興趣的試題
A. signal fail， signal degrade， manual switch
B. signal degrade， signal fail， manual switch
C. protection lockout， manual switch， path AIS
D. forced switch， manual switch， signal degrade
E. protection lockout， manual switch， forced switch
A. LEX
B. HDLC
C. GFP-F
D. PPP/BCP
You are provisioning an E-1 circuit on an ONS 15454 MS-SPRing configuration and XC-VXL-10G card. Each VC-12 connection must also terminate via the VC-3 matrix.
How many VC-3 ports remain after this circuit is created， assuming no other circuits？（）
A. 92
B. 93
C. 94
D. 95
E. 96
A. 1+1 is based on APS， while 1：1 is based on IPS.
B. 1：1 is used in SNCP switching， while 1+1 is used in MS-SPRing switching.
C. 1+1 sends signals on Working and Protect paths， while 1：1 sends signals only on Working path.
D. 1+1 sends signals on Working path ONLY， while 1：1 sends signals on both Working and Protect paths.
A. 10
B. 32
C. 64
D. 84
E. 96
最新試題
Which is a legitimate bandwidth matched pair？（）
What are three relevant design considerations when using the 15216 EDFA？（）
If node 2 is accepting line timing from node 1， node 2 will send （） to node 1 as its SSM messge.
How is SNCP and MS-SPRing traffic rerouted during a protection switch when a complete fiber cable cut occurs？（）
If the power is 0 dBm， what is the power in mW？（）
What three in combination are factors that can cause four-wave mixing in fiber-optic cables？（）
Given the formula： （Fiber Attenuation * Km） + （Splice Attenuation * # of Splices） + （Connector Attenuation * # of Connectors） + （Optical Fiber or OADM） + Buffer（Fiber aging）） With regard to SONET/SDH optical calculations， what will the given formula provide？（）
Click the Exhibit button. Which type of multiplexer is shown in the exhibit？（）
Click the Exhibit button. When designing a DWDM system with multiple amplified spans， a pre-amp is needed at Site B to （）.
Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems？（）